Royal Baby!

The first pictures of Wills, Cate and the new future King! You saw them here first….:)

 

Wills and Cate baby dolls

Advertisements

Restoration part three

So, time to clean up the peg. This one was tough going but after alot of sanding, repainting and varnishing she looks as good as new again:

April 28 013

The lace from the original was unusuable so I wrapped a new piece around the body of the peg and sewed it together up the back

April 28 014

I always sew where I can. It’s the only way to ensure she doesn’t all fall apart again! All that is left to do now is assemble her back together again….

A Christmas Angel peg project

Well, it’s been a long time since I managed to post a project so a good time for a new one and a seasonal one at that!

This lovely little festive angel is very easy to make, just follow the instructions below. Why not add our own embellishments to make her unique?

You will need:

Wooden peg, Gold fabric, Gold card , Gold thread, sequins/beads/embellishments/glitter, thread for hair, glue

1) Sand down the peg if preferred. I also varnished mine (you can use clear nail varnish) to make her last a bit longer.

2) Apply face transfer or draw on a face with felt tip pens. Try to make her look angelic!

3) Cut a circle of gold fabric. The diameter of the circle should be about twice the length of the peg. Find a plate to draw around or use a compass. I cut mine with pinking shears to make a crinkly edge. I also found another type of gold fabric so I cut another piece to add layers to her dress; you could use silk or organza if you have some.

4) Cut a small hole in the centre of the fabric circles. The easiest way to do this is to fold the circles in half, then again, then again and snip off the point.

5) Slip the fabric onto the peg through the hole in the desired order. Pull one slightly further down than the other so you can see the layers. I secured the underneath one in place with a dot of glue.

6) Wrap a gold thread (or colour of your choice!) around the body and over the raw edge of the top skirt. Finish off by tieing, glueing or sewing into place.

7) Wrap the thread for the hair around all four of your fingers about 5 times (more for a thinner thread). Slip off your fingers and tie around the middle with a piece of the same colour thread. Put some glue on the head of the peg, wait for it to go tacky then stick the hair onto the head. I separated mine into two at the back and tied them into bunches with a white thread.

8 ) Cut out one wing shape in paper. Place it onto the back of the gold card and draw around it. Flip the design over and draw around it again so you get two wing shapes that are mirror image of each other. Cut them out of the card carefully. Glue them onto the back of the body of the Angel.

9) Embellish your angel! I added a large sequin for her halo, glued sequins onto her wings and added a gold flower to her dress. Why not try some glitter for a really festive sparkle!

10) She’s finished!!!!

Post your finished angels here! Send you images to: www.dollypegdoll@yahoo.co.uk and I will add them to the gallery page. You can buy peg doll making materials, including pegs and transfer faces, from my website. Visit here: www.sarahhomfray.com/myshop and click on the peg doll category.

New peg doll kits

This little peg is now available as a kit. Choose from four different colour ways and embroider the apron yourself! Buy now from my online shop.

     

Available in the following colours: Red gingham, Blue gingham, Green gingham, Pale blue with white spots

Your kit provides everything you need including cotton print fabric, embroidery threads, 25 count linen, needle, face transfers (two just in case!), pipe cleaner and comprehensive instructions.